ATI PC325A-001 F-1A ProCharger (satin)
Please remember that the prices on our site are the Procharger Minimum Advertised Prices
Call 260 672-2076
ATI PC325A-001 F-1A ProCharger (satin)
Note: Pulley is not supplied with head unit
- The F-1A will bolt on to the bracket in place of a P-1SC or D-1SC.
- The F-1A has the same 9" volute diameter but is approx .38" longer in length, which normally doesn't pose any problems.
- The F-1A is a self contained blower, it holds 4oz of oil.
- The F-1A has a 5.40/1 gear ratio while the P-1SC and D-1SC has a 4.10/1 gear ratio. The 5.40/1 gear ratio of the F-1A means you don't use as small of a pulley to make boost. Larger pulleys give it better belt wrap (Example o/O)
- The F series of blowers have bearings that can handle the added forces of a cog drive. It is not recommended to run a P-1SC or D-1SC with a cog drive.
- A ProCharger Red Race Bypass Valve is recommended when using an F-1A, due to the amount of air the blower produces. Compressor surge can occur if the bypass valve is not large enough, this is very hard on the gearcase of the blower. Cracked welds on intercoolers can occur when the throttle is slammed shut and the bypass valve is too small, as can leaks in the intercooler hoses. Blower belts can slip too when the air has no-where to go.

Click To Enlarge
- Item #: ATI PC325A-001
- Manufacturer: ATI ProCharger (Accessible Technologies Inc)
- Condition: New
No Reviews. Write a Review