ATI MB001I-002 LT1 F Body Short Fan Shims

Quantity of three are included

1. Remove the wiring clips from both of the
fan motors.

2. Remove the four screws holding each
fan assembly to it’s shroud. Take the
fan assemblies out of the engine
compartment.

3. Loosen the nut holding the passenger’s
side fan blades to the fan motor (the
nut is reverse threaded). Set the nut and
blades aside for later reassembly.

4. Remove the three screws holding the
motor to the plastic housing. Pull the
motor out.

5. Place the longer fan spacers over the
mounting holes in the plastic housing.
Push the supplied screws through the
holes in the motor mounting flange.
Lower the motor down onto the spacers.
Thread the screws into the housing, and
tighten down.

6. Re-install the fan blades and tighten
down.

7. Repeat steps 3 thru 6 for the driver’s
side fan, using the shorter spacers.

8. Re-install both fans.